PolyMaker PolyMax White PLA

PolyMax™ PLA is a 3D printing material with excellent mechanical properties and printing quality. PolyMax™ PLA has an impact resistance of up to nine times that of regular PLA, and better overall mechanical properties than ABS.

 

Extremely Tough : Regular PLA is a very brittle material, which greatly limits its range of applications. PolyMax™ PLA was designed to change this. Featuring increased impact strength of up to 9 times that of regular PLA and 20% better than ABS, PolyMax™ PLA is a sure winner when it comes to toughness. So if you are looking for a material that can withstand your mechanically demanding tasks, PolyMax™ PLA is up to the challenge.

 

Uncompromised Quality : The good mechanical strength of PolyMax™ PLA is achieved with no compromise in printing quality. As PolyMax™ PLA is also produced with Jam-Free™ technology you can be certain you will get high quality prints with excellent strength while still enjoying the ease of printing PLA.

(PolyMaxWhite)

SKU PolyMaxWhite
Brand Polymaker
Shipping Weight 1.3500kg
Shipping Width 0.220m
Shipping Height 0.060m
Shipping Length 0.220m

Polymax is the best filament

By: on 20 June 2016
Polymax is the best filament that I have used, can't wait for polysmooth. the service at 3dprintergear is excellent
(5)

Actually stronger than my ABS

By: on 13 October 2015
Actually stronger than my ABS prints, really quite impressive. Nice warm white colour as well. Only slight grievance is that it doesn't glue well with superglue, though not much of a drawback. As always, very happy with 3Dprintergear's prices, range, and delivery
(5)

I've been using PolyMax on

By: on 8 October 2015
I've been using PolyMax on my Up Mini for about a week now, and have been thoroughly impressed with it so far. No failed prints, and no warping. The plastic does feel a bit softer than ABS and bends more easily, but that is a minor issue for me when the print quality is so good!
(5)

Good printing material

By: on 26 September 2015
I am very happy with this PloyMax filament. I'm printing with a "Deltaprintr", running at either 195 or 185, onto an unheated mirror that is coated with PVA glue. This is a product that I have no hesitation in recommending! The deliveries are prompt too :)
(5)

The PolyMax PLA worked flawlessly

By: on 7 November 2014
The PolyMax PLA worked flawlessly on the "Up Mini" the prints were strong warp free and the finish was good, my only complain is that the support material was a little hard to remove. I will be buying this product again.
(4)

Write a product review